|
||
Lowgas fuel economiser» Miscellaneous Items » [Overview] [LowGas] [Stickers] [Cases] [Asphalia] [Melatonin] [EMF Surveys] Lowgas fuel economiser - Further InformationThe fuel in your tank is a hydrocarbon, made from hydrogen and carbon molecules bound together. When the mixture is ignited in the presence of oxygen the combustion drives your engine by forcing the pistons up the engine's cylinders and thereby turning the wheels. The process is not all that efficient, however, particularly in older cars a good deal of the hydrogen never gets burned, escaping instead from your exhaust. By applying static magnetic fields to the fuel line the clusters become perturbed and disassembled so when the fuel reaches the combustion chamber materially more hydrogen atoms are available for combustion. This in turn has two effects: a) the energy per unit volume is increased (you get more miles per gallon) and b) the exhaust emissions of greenhouse gases are decreased. The concept is spreading and there are a number of magnetic fuel economisers now on the market. Their success over the years testifies to the efficacy of these devices, despite ignorant media attention from time to time. The manufacturers of the Lowgas fuel economiser looked at some 80 patents during their research and realised they all had one deficiency: the magnetic fields need to be very inhomogeneous, but nearly all the devices only used homogeneous fields, leading to a lower performance. Also the devices were difficult to fit or it was even necessary to cut the fuel line (strongly recommended against!). So they we came up with a simple solution which solves both problems: use a number of magnets, put them in a strip and wind them helically around the fuel line so that the fields point in many different directions. The result is Lowgas Gainex, very easy to fit and more effective than others on the market, as well as being a fraction of their cost. Instructions for useThe device is a long strip with five powerful magnets embedded in it. The strip has to be wound helically around the incoming fuel line as comfortably close to the engine entry point as possible, with the heat resistant side outwards (labelled "side") and then secured at each end with the cable ties provided. It may be wrapped either way round, with either end of the strip uppermost. In most cars this operation takes less than a minute or two. You can also detach the device and use strong gaffer tape to re-secure it should you change cars. | © Copyright EMFields 2005 - 2012 |
About Us |
Contact Us |
Terms and Conditions |
Privacy Policy |
Thanks to Javascript Array for sample menu code
|